Lash Care

HOW TO APPLY LASHES

1. Carefully remove your lashes out of the lash box. Try using our lash applicators when removing lashes to make it 10x better!
2. Be sure to cut and measure the lashes to your eye shape. You can do so by simply putting the lash up to your eye and look to see where needs to be removed. Remember, the inner corners of your lashes are the short/tapered ends!
3. Now that you've measured you lashes, trim the lash band so they fit perfectly and to avoid any discomfort! Tip: For a sharp and precise cut, try using our stainless steel scissors!
4. Apply 1 layer of lash adhesive (try out our lash adhesive in black AND white!). Allow glue to get tacky for about 40-60 seconds before apply the lash.
5. Using our Gold Lash Applicators, apply the lash on your lash line, giving you a natural lash look! Be sure to check that your inner corners are glued down to your eye and also make sure the ends of the lash aren't kicking up, if this does happen, try trimming your lash a little bit more!

Our lashes here at Queen Bee's Kollection can be worn up to 30 times, if you are taking good care of them. Each lash comes with their own lash box and lash brush (spoolie) so you can comb through the lash hairs. Putting the lashes back in the box after each wear preserves them for a longer wear and protects them from any dust or moisture.

Sleeping in your lashes is NOT recommended, but if it were to happen, carefully remove the lash, peel off any excess glue from the day or night before applied on the lash, and place back inside box. 

DO NOT tug on lash, doing this WILL cause damage to your lashes and the strip lash as well, which will then lead to the lash falling apart or look very sparse.

Lashes don't need to be washed, but if you were looking to wash them due to makeup falling on them or applying mascara, you can use a mild soap (i.e baby shampoo), warm water and a lash brush (spoolie) to comb through the hairs, and then allow to air dry.